Changing a Nav 2 from Trimble Brand to Case IH Brand Software
Page 1 of 1
Changing a Nav 2 from Trimble Brand to Case IH Brand Software
1. Download the lower version of Trimble Software available (Version 4.51)
2. Bring it down to that Version using the newest flash loader (make sure that the old flash loader 200 is not on there)
3. Close the new flash loader and do a power cycle
4. Use the Old flash loader 200 to bring it to CNH Version software 3.72 (you will get a warning, just click OK
5. Close out of the flash loader
6. Do another power cycle
7. While it is off Take out the USB out that has the old flash loader version on it
8. Bring it up to whatever CNH software version you would like using the New Flash loader
2. Bring it down to that Version using the newest flash loader (make sure that the old flash loader 200 is not on there)
3. Close the new flash loader and do a power cycle
4. Use the Old flash loader 200 to bring it to CNH Version software 3.72 (you will get a warning, just click OK
5. Close out of the flash loader
6. Do another power cycle
7. While it is off Take out the USB out that has the old flash loader version on it
8. Bring it up to whatever CNH software version you would like using the New Flash loader
Similar topics
» Creating an Omnistar or Trimble GPS Signal (G2, XP, HP, RTX)
» XCN 2050 Display Software Update from Version 2.5
» XCN 2050 Display Software Update from Version 2.5
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum